3D Ornaments
This file comes with all the pieces you need to create the ornament shown. The pieces are sizeable to fit your needs and are compatible with both the 8x12 and 12x12 mats.
Here is the tutorial:
2. Adhere two pieces together angling them as shown making sure to line up the holes.
3. Adhere in the third piece, lining up the holes.
4. Cut a 18" piece of ribbon and push it through to the bottom of the ornament. Tie in a double knot.
5. Begin pushing the ribbon up through the top holes.
6-7. Continue bringing the ribbon up through the holes.
8. Once you have all the holes through your ribbon, pull the ribbon up while slightly pushing down on the ornament sides.
9. Tie the ribbon around itself to form a loop then trim the end of the ribbon off.
Here is the tutorial:
2. Adhere two pieces together as shown making sure to line up the holes.
3. Adhere in the third piece, lining up the holes.
4. Adhere in the fourth piece, lining up the holes.
5. Cut a 18" piece of ribbon and push it through to the bottom of the ornament. Tie in a double knot.
6. Begin pushing the ribbon up through the top holes.
7-8. Continue bringing the ribbon up through the holes.
9. Once you have all the holes through your ribbon, pull the ribbon up while slightly pushing down on the ornament sides.
10. Tie the ribbon around itself to form a loop then trim the end of the ribbon off.
11. Your finished ornament will look similar to this.
You can find the Silhouette files here
and the SVG files here.
Tags:
3D
Bits of Paper
Christmas
Jamie Cripps
Jamie Lane Designs
Ornament
Paper Ornaments
Silhouette
SVG
Tutorial
2 comments