3D Paper Bow
This bows comes with all the pieces shown and is compatible with both the 8x12 and 12x12 mats. You can also size the bow to fit your needs! These would be so cute on top of gifts or even to go on Tags!
1. Cut out all the pieces. Layer the long pieces and adhere in place.
2. Place adhesive on the back center of the long piece. Bend one side over to the center as shown.
3. Bend the other side over and adhere as you did the other.
4. Place adhesive on the center piece and adhere it to the back side. Flip the piece over.
5. Layer and adhere the bow backing in place. Your pieces should look similar to this image now.
6. Using foam adhesive, adhere the center of the bow to the bow backing.
Tags:
3D Paper Bow
3D Tutorial
Bits of Paper
Bow
Gift Topper
Jamie Cripps
Jamie Lane Designs
Paper Bow
0 comments