Friday, February 28, 2014


Fringed and Spring 3D Paper Flowers!

Tutorial:
1.  Cut out all the pieces and pinch the leaves on the score lines.  Ink around the edges of the flower pieces if desired.
2.  Use a skewer (or pencil) to bend the petals of each flower, pinching them in the center around the skewer then place adhesive on the straight edge of the fringe piece as shown.
3.  Tightly roll the fringe piece.
4.  Fluff out the fringes so it looks similar to this now.
5-8.  Start with the largest flower working your way to the smallest...adhere the centers together and stagger the petals.
9.  Adhere your leaf pieces together.
10.  Turn your fringe piece over and place adhesive on the bottom layer tabs as shown.
11.  Insert the fringe piece into the center of the flower.
12.  Place a large glue dot (or hot glue) on the top of your leaf piece and adhere it to the flower, securing the center fringe piece.
13.  Your flower should look like this now! 


Tutorial:
1.  Cut out all the pieces and pinch the leaves on the score lines.  Ink around the edges of the flower pieces if desired.
2.  Adhere the center pieces together, matching up the circles in the center but staggering the tips. Bend the pieces up so your center looks like this now.
3.  Next grab the cone piece and insert the tab into the slot then bend out the small triangle shapes.
4.  Use a skewer (or pencil) to bend the petals of each flower, pinching them in the center around the skewer.
5.  Adhere the flowers together, staggering the petals.
6.  Turn over your cone shape and place adhesive on the triangles.
7.  Adhere the piece to the flower petal.
8.  Insert your flower center and adhere.
9.  Adhere the two leaf pieces together then place a small foam adhesive in the center as shown.
10.  Adhere the leaf piece to the bottom of the flower.
11.  Your flower should look like this now!



No comments:

Related Posts Plugin for WordPress, Blogger...