This file contains only the bottom pieces shown in the image - hair bow is not included.
The file comes with two chevron tales and a center rectangle piece sized to fit a 3" hair bow. You can reduce the size to fit your bow width, just make sure to keep everything grouped together to keep proper proportions.
Instructions: Cut the pieces with heat transfer vinyl, assemble your bow as normal then iron on the bottom chevrons. Fold the bottom end of the bow tale in half and cut along the "v" shape of the chevron. Repeat for the other side. For the center, iron on the rectangle piece to a 1/4" width of ribbon. Hot glue around the center of the bow.
You can use this file to create a single bottom as well,
just ungroup and remove the smallest chevron.
You can find this file in my stores soon!
This Hair Bow Holder is perfect for hanging your bows large or small. It is made to fit bows with ponytail holders and is compatible with the 8x12 and 12x12 mats. The file comes with the main card and a mat. Cut the main card with Silhouette Chipboard to give the card more strength!
Here's the tutorial:
You can find this file in my stores soon!
Cut 4 ribbons about 8" long of 1-1/2" wide wired ribbon.
Begin by tying a knot in the first piece.
Pull the knot tight.
Tie the second piece around the first, centering the knots.
Tie the third piece around the others, centering the knots.
Finally tie the fourth third piece around the others, centering the knots. Trim the pieces so they are all similar in length, cutting a triangle in each end. Fluff the ribbon as desired.
Flip the bow over and insert your hair clip through one of the slots created from the tie.
This bow is easy to slip off and on so you can change it quickly to coordinate!
Using different widths and patterns will change the look and size as well!
Thanks so much for stopping by!
