Easter Treats

Chocolate Kiss Holder with Bow

This chocolate dollop fold-over candy holder holds 4 chocolate dollops. The holder is approximately 4-1/4" x 2-3/4" x 1" when assembled. The file comes with the base, coordinating mats, the center candy holder, and the twist bow.

For these fold-over candy holders:

1. Cut out all your pieces and fold on the score lines.

2. Adhere mats to the front top and front bottom. Cut additional if you'd like the other areas covered.

3. For the candy insert, fold on the score lines.  Place strong adhesive on the back of the rectangle as well on the two small side tabs.  Adhere the two side tabs to the backing so it forms the "box" shelf shape.  Adhere the entire piece to the center of the inside.

4. Fill with four chocolate kisses/dollops and embellish as desired!

Chocolate Kiss Holder with Bunny

This chocolate dollop fold-over candy holder holds 4 chocolate dollops. The holder is approximately 4-1/4" x 2-3/4" x 1" when assembled. The file comes with the base, coordinating mats, the center candy holder, and the bunny with the tail.

Bunny Kisses Chocolate Holder

The assembled project is approximately 3-1/2" X 4-3/4" X 1" and it holds five chocolate dollop candies.  This box has a pocket to hold a gift note or a standard sized gift card.  The file comes with the box base, the sentiment mat, the note card, and the bunny silhouette.  The file is compatible with both the 8x12 and 12x12 mats.  

Here is the tutorial:

1.  Cut out all your pieces and fold on the score lines. Add Adhesive to the front as shown with the white tape.  Remember to keep the inside of the letters!

2.  Flip the box over and add adhesive as shown in the image.

3.  Fold down the rectangle piece with the half circle and adhere to itself.  This will form the pocket to hold the note card or gift card.

4. Fold up the box and adhere the back panel to the box to form the kiss holder.

5. Fold in your side tabs.

6. Adhere the last tab down.

7. Repeat for the other side.  Your box should look like this now!

8. Adhere your sentiment mat in place.

9. To adhere the inside of the letters, I use the letter itself as a template.  Without any glue, place the "B" in place. Put glue inside the B areas.

10. Adhere the inside B's in place.

11. Remove the letter "B".

12. Adhere the bunny with foam adhesive then embellish and fill as desired!  I insert my kisses with the box completed.  You can insert them before closing the sides if you like.

Hoppy Easter Chocolate Holder

The assembled project is approximately 3-1/2" X 4-3/4" X 1" and it holds five chocolate dollop candies.  This box has a pocket to hold a gift note or a standard sized gift card.  The file comes with the box base, the sentiment mat, the note card, and the layered bunny silhouette.  The file is compatible with both the 8x12 and 12x12 mats.  

Easter tags: