French Fry Boxes!

I am so excited about these boxes!  These are my new French Fry Boxes and they have SO many possibilities!  You can put all sorts of goodies in these boxes; handmade munchies, school supplies, crayons, or party treats...even french fries!  :)

These boxes come size at approximately 4-1/4" x 3-1/2" x 1" and are compatible with both the 8x12 and 12x12 mats.  The files are sizable so you can make them larger or smaller to fit your needs.

3D French Fry Treat Box

This box comes with the box base, the box band, 

two label pieces, five fry boxes, and five crinkle mats!

Here is the tutorial:

1.  Cut out the box and fold/bend on the score lines.  Place adhesive on the two front tabs (they go under the back tabs).
2.  Adhere the back tabs on top of the front tabs.
3.  Your box should look like this.
4.  Cut out your fry boxes and fold on the score lines.
5.  Place adhesive on the side tab.
6.  Adhere the side tab to the box.
7.  Pop the box up to form its shape and tuck in the bottom flap.
8.  Accordion fold the crinkles then ink the edges and peaks.
9.  Place adhesive on the back of the two ends (only) of the accordion fold.
10. Adhere one end down at the top of the box.
11. Stretch the crinkle and adhere the other end to the bottom edge of the box.  If you want all sides of the fry covered, you can cut more pieces out.  I only did the front side of my fries.
12.  Place your fries in your box and fill as desired!  The opening is approximately 3/4" square x 4" in length.
13.  Cut the box band out and fold on the score lines.  Adhere the tab to the side to form a rectangle.
14.  Slide the band around the box.  I use a little bit of adhesive to hold it in place.
15.  Assemble the labels and adhere to the band with foam adhesive.  Embellish as desired!

3D French Fry Box with Mats

This box comes with the box base, 

two label pieces, and coordinating mats.

3D Lower Scallop French Fry Box with Flower

This box comes with the box base, coordinating mats,

 a lower scallop piece, leaf pieces and a rolled flower.

3D Scallop French Fry Box with Mats

This box comes with the box base,  

two label pieces, and coordinating mats.

3D French Fry Box with Handle

This box comes with the box base, box handle

three stars, and coordinating mats.

Here's how to get the handle on!

1.  Adhere your patterned paper strip on your handle then tuck your handle into each slot on the back box sides.  Apply adhesive to the front tabs.
2.  Adhere the back tabs over the front tabs.  
3.  Adhere your mats in place, the inside mats will hide the handle bits that are showing.

You can find all of these files HERE!